For driving on roads, the “SunBrush® mobile” is simply swiveled to the side of the tractor.
Since the ideal use on rainy days, you can also use bad weather periods optimally and efficiently.
Swiveling the cleaning roller through 180 degrees ensures efficient work.
The joystick is attached to the windshield of the cabin with a suction cup and powered by a power outlet.
This joystick allows the driver to perform all functions (lifting, lowering, swiveling, kinking).
|carrier vehicle||tractor, farm loaders|
|attachment||device is attached via front linkage (cat. 2) directly or using an adapter;|
|drive||fully hydraulic; tractor requirements: continuous hydraulic power of at least 40 l/minute at approx. 200 bar
on site requirements: plug-in coupling flow, pressure less return or double-action control unit
|oil||mineral or synthetic oils¸ on site the vehicle|
|operating temperature||-20°C to +60°C|
|weight||aprrox 480 kg, considering a brush length of 4.5 meters|
|control unit||12 Volt-version (protection of the on-site installed two-pin power socket by a 15 A fuse)
CANBUS-control via Joy-Stick (lift, lower, slew)
24 Volt-version (Protection of the on-site installed two-pin power socket by a 15 A fuse)
PLC-control via Joy-Stick (lift, lower, slew)
|driving speed||recommended: approx. 1,5 – 2,5 km/h|
|brush length||variable, from 4 – 7.5 meters (indicate at time of order)|
|brush diameter||300 mm|
|brush material||UV-resistant mixture of plastics for a gentle cleaning of glass surfaces|
|brush speed:||The brush speed should not exceed 120-150 rpm. The speed can be regulated by the accelerator pedal or the throttle at the swivel joint.|
||installed on the carrier console at the backside of the tractor. This enables a fast and easy change of water tanks.|
|tank bracket||attachable to a three-point rear hitch for a fast change of the water tanks|
|the water pump is racked on the rear power takeoff; variable at
540 revolutions; prefiltered
optional: water supply also may be provided by a 220 Volt-pump including a pressure cutoff and a filter unit
|Powered by a hydraulic motor connected in parallel to the brush|
|filter||the water filter should be cleaned regularly by leaching this ensures proper functionality|
|water consumption||varying, depending on pollution, weather and driving speed|
|water quality||only use rainwater or softened water for the cleaning process
Do not utilize hard water
You can process hard water whilst adding “SunBrush Blue”
Leveling – balance/settings
The back pressure in the bladder controls the contact pressure in between cleaning brush and module table. The pressure must be set once bevor the cleaning process. When used correctly, the brush always rests with a constant pressure on the modules even if the carrier vehicle drives on an uneven ground.
The back pressure depends on the brush lengths and type of modules.
Frameless modules require a contact force of 5 kg per brush meter.
Framed modules require a contact force of 5-8 kg per brush meter
|brush length||contact force||pressure setting|
|4 meter||8 kg||50 bar|
|4 meter||5 kg||60 bar|
|7,5 meter||8 kg||95 bar|
|7,5 meter||5 kg||110 bar|