|carrier vehicle||concrete pump|
|attachment||Attached to the quick change system using an adapter|
|drive||Powered hydraulically by the vehicle|
|oil||mineral or synthetic oils¸ on site the vehicle|
|operating temperature||-20°C to +60°C|
|weight||aprrox 480 kg, considering a brush length of 4.5 meters|
|control unit||Radio control from the vehicle|
|brush length||4.5 meter|
|brush diameter||300 mm|
|brush material||UV-resistant mixture of plastics for a gentle cleaning of glass surfaces|
|brush speed:||The brush speed should not exceed 120-150 rpm.|
|water tank||Own water tank – quantity up to 4000 l|
|water pump||Water supply via the vehicle|
|filter||the water filter should be cleaned regularly by leaching this ensures proper functionality|
|water consumption||varying, depending on pollution, weather and driving speed|
|water quality||only use rainwater or softened water for the cleaning process
Do not utilize hard water
You can process hard water whilst adding “SunBrush Blue”
Leveling – balance/settings
The back pressure in the bladder controls the contact pressure in between cleaning brush and module table. The pressure must be set once bevor the cleaning process. When used correctly, the brush always rests with a constant pressure on the modules even if the carrier vehicle drives on an uneven ground.
The back pressure depends on the brush lengths and type of modules.
Frameless modules require a contact force of 5 kg per brush meter.
Framed modules require a contact force of 5-8 kg per brush meter.
|Brush length||contact force||pressure setting|
|4 meter||8 kg||50 bar|
|4 meter||5 kg||60 bar|
|7,5 meter||8 kg||95 bar|
|7,5 meter||5 kg||110 bar|